iTEMP TMT142B Technical data
Endress+Hauser 59
Cable entries
Version Type
Thread 3x thread ½" NPT
3x thread M20
3x thread G½"
Connecting cable Cable specification
• A normal device cable suffices if only the analog signal is used.
• A shielded cable is recommended for HART
®
communication. Observe grounding concept
of the plant.
• The terminals for the fieldbus connection have integrated polarity protection.
• Cable cross-section: max. 2.5 mm²
13.7 Certificates and approvals
CE mark The product meets the requirements of the harmonized European standards. As such, it
complies with the legal specifications of the EC directives. The manufacturer confirms
successful testing of the product by affixing to it the CE-mark.
EAC mark The product meets the legal requirements of the EEU guidelines. The manufacturer
confirms the successful testing of the product by affixing the EAC mark.
Ex approvals More information on the hazardous area versions currently available (ATEX, CSA, etc.) is
available from your supplier. Separate Ex documentation contain all the data relevant for
explosion protection.
CSA C/US The product complies with the requirements of "CLASS 2252 06 - Process Control
Equipment" and "CLASS 2252 86 - Process Control Equipment - Certified to US Standards".
HART
®
certification
The temperature transmitter is registered by the FieldComm Group. The device meets the
requirements of the HART
®
Communication Protocol Specifications, Revision 7.
Radio approval The device has Bluetooth® radio approval in accordance with the Radio Equipment
Directive (RED) for Europe and the Federal Communications Commission (FCC) 15.247 for
North America.
Europe
This device meets the requirements of the Telecommunications Directive RED
2014/53/EU:
• EN 300 328
• EN 301 489-1
• EN 301 489-17
To Next Page
Loading...
