11 Operation using PROFIBUS
®
PA TMT84
82 Endress + Hauser
Unit read/
write
For selecting the output unit.
Factory settings:
Analog Input function block = 0x07CD (1997)= none
! Note!
OUT UNIT (output unit) does not affect measured value
scaling.
Decimal Point read/
write
Specifies the number of places after decimal point for the
output value "Out value".
! Note!
This parameter is not supported by the device.
Upper limit alarm read/
write
Entry of the alarm limit value for the upper alarm
(HI HI ALM). If the output value OUT exceeds this limit
value, then the HI HI ALM alarm status parameter is out-
put.
User input:
Unit from OUT SCALE
Factory settings:
max value
Upper limit warning read/
write
Entry of the alarm limit value for the upper warning
(HI ALM). If the output value OUT exceeds this limit
value, then the HI ALM alarm status parameter is output.
User input:
Unit from OUT SCALE
Factory settings:
max value
Lower limit warning read/
write
Entry of the alarm limit value for the lower warning
(LO ALM). If the output value OUT is below this limit
value then the LO ALM alarm status parameter is output.
User input:
Unit from OUT SCALE
Factory settings:
min. value
Lower limit alarm read/
write
Entry of the alarm limit value for the lower alarm
(LO LO ALM). If the output value OUT is below this limit
value then the LO LO ALM alarm status parameter is out-
put.
User input:
Unit from OUT SCALE
Factory settings:
min. value
Analog Input
Menu item Parameter
"Communication" Name
Parame-
ter access
Description
To Next Page
Loading...
