Endress+Hauser Levelflex FMP53 - Materials: GT19 Housing (Plastic)

Levelflex FMP53
58 Endress+Hauser
Materials: GT19 housing
(plastic)
2.1
1
2.2
5.2
5.1
6
7
8
9
4
A0013788
No. Component part Material
1 Housing PBT
2.1 Electronics compartment cover • Sight glass: PC
• Rim: PBT-PC
• Cover seal: EPDM
• Thread coating: graphite-based lubricant varnish
2.2 Connection compartment cover • Cover: PBT
• Cover seal: EPDM
• Thread coating: graphite-based lubricant varnish
4 Safety device on housing neck • Screw: A4-70
• Clamp: 316L (1.4404)
5.1 Dummy plug, coupling, adapter or connector
(depending on device version)
• Dummy plug, depending on device version:
• PE
• PBT-GF
• Coupling, depending on device version:
• Brass (CuZn), nickel-plated
• PA
• Adapter: 316L (1.4404/1.4435)
• Seal: EPDM
• Connector M12: brass, nickel-plated
1)
• Connector 7/8": 316 (1.4401)
2)
5.2 Dummy plug, coupling or adapter (depending on
device version)
• Dummy plug, depending on device version:
• PE
• PBT-GF
• Steel, galvanized
• Coupling, depending on device version:
• Brass (CuZn), nickel-plated
• PA
• Adapter: 316L (1.4404/1.4435)
• Seal: EPDM
6 Dummy plug or M12 socket (depending on device
version)
• Dummy plug: brass (CuZn), nickel-plated
• M12 socket: GD-Zn, nickel-plated
7 Pressure compensation vent Brass (CuZn), nickel-plated
8 Ground terminal • Screw: A2
• Spring washer: A4
• Clamp: 304 (1.4301)
• Bracket: 304 (1.4301)
9 Adhesive nameplate Plastic
1) In the version with M12 connector, the seal material is Viton.
2) In the version with 7/8" connector, the seal material is NBR.