Levelflex FMP53
Endress+Hauser 75
Certificates and approvals
Currently available certificates and approvals can be called up via the product configurator.
CE mark
The measuring system meets the legal requirements of the applicable EU Directives. These are listed
in the corresponding EU Declaration of Conformity along with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
RoHS
The measuring system complies with the substance restrictions of the Restriction on Hazardous
Substances Directive 2011/65/EU (RoHS 2).
RCM-Tick marking
The supplied product or measuring system meets the ACMA (Australian Communications and Media
Authority) requirements for network integrity, interoperability, performance characteristics as well
as health and safety regulations. Here, especially the regulatory arrangements for electromagnetic
compatibility are met. The products are labelled with the RCM- Tick marking on the name plate.
A0029561
Ex approval
The devices are certified for use in hazardous areas and the relevant safety instructions are provided
in the separate "Safety Instructions" (XA, ZD) document. Reference is made to this document on the
nameplate.
The separate "Safety Instructions" documentation (XA) containing all the relevant explosion
protection data is available from your Endress+Hauser sales organization.
Dual seal according to
ANSI/ISA 12.27.01
The devices have been designed according to ANSI/ISA 12.27.01 as dual seal devices, allowing the
user to waive the use and save the cost of installing external secondary process seals in the conduit
as required by the process sealing sections of ANSI/NFPA 70 (NEC) and CSA 22.1 (CEC) These
instruments comply with the North-American installation practice and provide a very safe and cost-
saving installation for pressurized applications with hazardous fluids.
Further information can be found in the Safety Instructions (XA) of the relevant devices.
Functional safety
Use for level monitoring (MIN, MAX, range) up to SIL 3 (homogeneous redundancy), independently
evaluated by TÜV Rheinland in accordance with IEC 61508, refer to the "Functional Safety Manual"
SD00326F for more information.
Overfill prevention WHG
DIBt Z-65.16-501
Hygienic compatibility
Information regarding device versions that meet the requirements of 3A Sanitary Standard No. 74
and/or are certified by the EHEDG:
SD02503F
Suitable fittings and seals must be used to ensure hygiene-compliant design according to 3A
and EHEDG specifications.
Comply with the maximum permitted temperature of the process seal.
The gap-free connections can be cleaned of all residue using the typical cleaning methods
within this industry (CIP and SIP).
ASME BPE (CoC)
Certificate of Compliance (CoC)
• Product structure, feature 590 "Additional approval", version "LW"
• Wetted materials made of 316L with delta ferrite < 3 %
• Surface roughness R
a
< 0.38 μm (15 μin)
• Information regarding ASME BPE conformity
To Next Page
Loading...
