Endress+Hauser Liquiline CM442R - Output

Liquiline CM442R/CM444R/CM448R Technical data
Endress+Hauser 151
15.4 Output
15.4.1 Output signal
Depending on version:
• 2 x 0/4 to 20 mA, active, potentially isolated from one another and from the sensor circuits
• 4 x 0/4 to 20 mA, active, potentially isolated from one another and from the sensor circuits
• 6 x 0/4 to 20 mA, active, potentially isolated from one another and from the sensor circuits
• 8 x 0/4 to 20 mA, active, potentially isolated from one another and from the sensor circuits
• Optional HART communication (only via current output 1:1)
HART
PROFIBUS DP
Modbus RS485
Signal encoding FSK ± 0.5 mA via current signal
Data transmission rate 1200 Baud
Galvanic isolation Yes
Load (communication resistor) 250 
Signal encoding EIA/TIA-485, PROFIBUS-DP-compliant as per IEC 61158
Data transmission rate 9.6 kBd, 19.2 kBd, 45.45kBd, 93.75 kBd, 187.5 kBd, 500 kBd, 1.5 MBd,
6MBd, 12MBd
Galvanic isolation Yes
Bus termination Internal slide switch with LED display
Signal encoding EIA/TIA-485
Data transmission rate 2400, 4800, 9600, 19200, 38400, 57600 and 115200 Baud
Galvanic isolation Yes
Bus termination Internal slide switch with LED display