Endress+Hauser Liquiline CM442R - Page 54

Operation Liquiline CM442R/CM444R/CM448R
54 Endress+Hauser
10.1.3 Device status
Icons on the display alert you to special device states.
Chlorine,
amperometric
Chlorine Chlorine, temperature Main value, Raw value, Temperature
Nitrate Nitrate Nitrate, temperature Main value, Raw value, Temperature
Spectral
absorption
coefficient (SAC)
SAC SAC, temperature Main value, Raw value, Temperature
Sludge level Turbidity Turbidity, temperature Main value, Raw value, Temperature
Ammonium,
ion-sensitive
Ammonium Ammonium, temperature Main value, Raw value, Temperature
Nitrate,
ion-sensitive
Nitrate Nitrate, temperature Main value, Raw value, Temperature
Potassium,
ion-sensitive
Potassium Potassium, temperature Main value, Raw value, Temperature
Interface
measurement
UIS UIS UIS, turbidity
also: graphic display
Icon Location Description
Title bar Diagnostic message "Failure"
Title bar Diagnostic message "Maintenance request"
Title bar Diagnostic message "Check"
Title bar Diagnostic message "Out of specification"
Title bar Fieldbus or TCP/IP communication active
Title bar Hold active
At measured value Hold for the actuator (current output, limit contactor etc.) is active
At measured value
1)
An offset has been added to the measured value
At measured value Measured value in "Bad" or "Alarm" state
At measured value Automatic temperature compensation active
At measured value Manual temperature compensation active
Title bar Simulation mode active or Memocheck SIM connected
Sensor type Main value Main / secondary
measured value
All values