13
Version 1: "Hard grounding"
• Place the cable shield on the "Fixing plate".
• Connect the cable wires as per the assignment.
Version 2: "Capacitive grounding"
• Strip back the shield braiding, push the extension wire of the C module (pos. 1) onto the exposed shield and
fasten the clip:
• Place the extension wire on the "Fixing plate".
• Connect the cable wires as per the assignment.
Version 3: Fieldbus connection socket (accessories):
• Screw the fieldbus connection socket (accessories) into the housing bushing.
• Trim the connection cores of the socket to approx. 15 cm (5.9 ").
• Connect the cable cores as per the assignment. In doing so, you must place the cable shield (GN/YE) on the
"Fixing plate".
a0004060
View in device (CPU module)
a0001640
Wiring diagram
a0004071
View in device (CPU module)
a0004073
Wiring diagram
To Next Page
Loading...
