Liquiphant FTL64
40 Endress+Hauser
Explosion-protected smartphones and tablets
If used in hazardous areas, mobile end devices with an Ex approval must be used.
Overfill protection
Before mounting the device, observe the documentation from the WHG approvals (German Federal
Water Act).
Approved for overfill protection and leakage detection.
Ordering information: Product Configurator, order code for "Additional approval", option "LD"
Functional safety
The Liquiphant has been developed according to the IEC 61508 standard. The device is suitable for
overfill prevention and dry-running protection up to SIL 2 (SIL 3 with homogeneous redundancy).
For a detailed description of the safety functions with the Liquiphant, settings and functional safety
data, see the "Functional Safety Manual" on the Endress+Hauser website: www.endress.com →
Downloads.
Ordering information: Product Configurator, order code for "Additional approval", option "LA"
Subsequent confirmation of usability according to IEC 61508 is not possible.
Marine certificate
• ABS (American Bureau of Shipping), option "LF" → pending
• LR (Lloyd's Register) marine approval, option "LG" → pending
• BV (Bureau Veritas) marine approval, option "LH" → pending
• GL (German Lloyd)/DNV (Det Norske Veritas), option "LJ" → pending
Ordering information: Product Configurator, order code for "Additional approval", for option see
items listed.
Radio approval
Further information and the documentation currently available can be found on the
Endress+Hauser website: www.endress.com → Downloads.
CRN approval
Versions with a CRN approval (Canadian Registration Number) are listed in the corresponding
registration documents. CRN-approved devices are marked with a registration number.
Any restrictions regarding the maximum process pressure values are listed on the CRN certificate.
Ordering information: Product Configurator, order code for "Additional approval", option "LS"
Test reports Test, certificate, declaration
The following documents can be ordered:
• Inspection certificate 3.1, EN10204 (material certificate, wetted parts)
• NACE MR0175 / ISO 15156 (wetted parts), declaration
• NACE MR0103 / ISO 17945 (wetted parts), declaration
• AD 2000 (wetted parts), declaration, excluding cast parts
• ASME B31.3 Process Piping, declaration
• Pressure test, internal procedure, test report
• Helium leak test, internal procedure, test report
• Material identification check (PMI), internal procedure (wetted parts), test report
• Penetrant testing AD2000-HP5-3(PT), wetted/pressurized metal parts, inspection certificate
• Penetrant testing ISO23277-1 (PT), wetted/pressurized metal parts, inspection certificate
• Penetrant testing ASME VIII-1 (PT), wetted/pressurized metal parts, inspection certificate
• Welding documentation, wetted/pressurized seams
Ordering information: Product Configurator, order code for "Additional approval", option "LS"
The documentation currently available can be found on the Endress+Hauser- website:
www.endress.com → Downloads or using the serial number of the device under Online Tools in
the Device Viewer.
To Next Page
Loading...
