Endress+Hauser Micropilot FMR60B - Table of Contents

Micropilot FMR60B PROFINET with Ethernet-APL Table of contents
Endress+Hauser 3
Table of contents
1 Symbols .......................................................................... 4
1.1 Safety symbols ........................................................................ 4
1.2 Symbols for certain types of information and graphics ........................................... 4
2 Requirements for personnel ...................................................... 5
3 Intended use ...................................................................... 5
4 Workplace safety ................................................................. 6
5 Operational safety ................................................................ 6
6 Product safety .................................................................... 6
7 Incoming acceptance .............................................................. 7
8 Product identification ............................................................. 7
8.1 Nameplate ........................................................................... 7
8.2 Manufacturer address ................................................................... 8
9 Storage and transport ............................................................. 8
9.1 Storage conditions ..................................................................... 8
9.2 Transporting the product to the measuring point ............................................... 8
10 Mounting ......................................................................... 8
10.1 General instructions .................................................................... 8
10.2 Mounting requirements ................................................................. 9
10.3 Mounting the measuring device ...........................................................11
10.4 Post-mounting check .................................................................. 15
11 Electrical connection ............................................................ 16
11.1 Connecting requirements ............................................................... 16
11.2 Connecting the device .................................................................. 18
11.3 Ensuring the degree of protection ......................................................... 24
11.4 Post-connection check ..................................................................24
12 Operation ....................................................................... 25
12.1 Reading off the device locking status ....................................................... 25
12.2 Reading off measured values ............................................................. 25
12.3 Adapting the device to process conditions ................................................... 25
13 Commissioning .................................................................. 25
13.1 Preliminaries ........................................................................ 25
13.2 Function check ....................................................................... 25
13.3 Establishing a connection via FieldCare and DeviceCare ......................................... 26
13.4 Configuring the operating language ....................................................... 27
13.5 Configuring the device ................................................................. 28