Endress+Hauser Micropilot FMR60B - Workplace safety; Operational safety; IT security

Micropilot FMR60B PROFINET with Ethernet-APL Mounting
Endress+Hauser 9
1. Install the device or turn the housing so that the cable entries do not point upwards.

A0029263
2. Always firmly tighten the housing cover and the cable entries.
3. Counter-tighten the cable entries.
4. A drip loop must be provided when laying the cables.
10.2 Mounting requirements
10.2.1 Internal vessel fittings
α
A0031777
Avoid internal fittings (point level switches, temperature sensors, struts, vacuum rings,
heating coils, baffles etc.) inside the signal beam. Pay attention to the beam angle α.