Endress+Hauser Micropilot FMR60B - Basic safety instructions; Requirements for personnel; Intended use

Storage and transport Micropilot FMR60B PROFINET with Ethernet-APL
8 Endress+Hauser
• Firmware version, hardware version
• Approval-related information, reference to Safety Instructions (XA)
• DataMatrix code (information about the device)
8.2 Manufacturer address
Endress+Hauser SE+Co. KG
Hauptstraße 1
79689 Maulburg, Germany
Place of manufacture: See nameplate.
9 Storage and transport
9.1 Storage conditions
• Use the original packaging
• Store the device in clean and dry conditions and protect from damage caused by shocks
9.1.1 Storage temperature range
See Technical Information.
9.2 Transporting the product to the measuring point
L
WARNING
Incorrect transport!
The housing or sensor can be damaged or pull off. Risk of injury!
‣
Transport the device to the measuring point in its original packaging or by the process
connection.
‣
Always secure lifting equipment (slings, eyes, etc.) at the process connection and never lift
the device by the electronic housing or sensor. Pay attention to the center of gravity of the
device so that it does not tilt or slip unintentionally.
10 Mounting
10.1 General instructions
L
WARNING
Loss of protection rating if the device is opened in a wet environment.
‣
Only open the device in a dry environment!