Micropilot FMR60B PROFINET with Ethernet-APL Requirements for personnel
Endress+Hauser 5
2 Requirements for personnel
The personnel must fulfill the following requirements for its tasks:
‣
Trained, qualified specialists must have a relevant qualification for this specific function
and task.
‣
Personnel must be authorized by the plant owner/operator.
‣
Personnel must be familiar with federal/national regulations.
‣
Before starting work: personnel must read and understand the instructions in the manual
and supplementary documentation as well as the certificates (depending on the
application).
‣
Personnel must follow instructions and comply with general policies.
3 Intended use
Application and media
The measuring device described in these Operating Instructions is intended for continuous,
non-contact level measurement in liquids, pastes and sludges. Because of its operating
frequency of approx. 80 GHz, a maximum radiated peak power of 6.3 mW and an average
output power of 63 µW, unrestricted use outside of closed, metallic vessels is also permitted
(for example over basins or open channels). Operation does not pose any danger whatsoever
to humans and animals.
If the limit values specified in the "Technical data" and the conditions listed in the instructions
and additional documentation are observed, the measuring device may be used for the
following measurements only:
‣
Measured process variables: level, distance, signal strength
‣
Calculated process variables: volume or mass in vessels of any shape; flow through
measuring weirs or channels (calculated from the level by the linearization functionality)
To ensure that the measuring device remains in proper condition for the operation time:
‣
Use the measuring device only for media against which the process-wetted materials are
adequately resistant.
‣
Observe the limit values in the "Technical data".
Incorrect use
The manufacturer is not liable for damage caused by improper or non-intended use.
Avoid mechanical damage:
‣
Do not touch or clean device surfaces with pointed or hard objects.
Clarification of borderline cases:
‣
For special fluids and fluids for cleaning, Endress+Hauser is glad to provide assistance in
verifying the corrosion resistance of fluid-wetted materials, but does not accept any
warranty or liability.
Residual risks
Due to heat transfer from the process as well as power loss in the electronics, the temperature
of the electronics housing and the assemblies it contains (e.g. display module, main
To Next Page
Loading...
