Proline Promag 50H, 53H
48 Endress+Hauser
Sanitary compatibility • 3A approval and EHEDG-tested
• Seals → conform to FDA (apart from Kalrez seals)
Other standards and
guidelines
• EN 60529
Degrees of protection by housing (IP code)
• EN 61010
Protection Measures for Electrical Equipment for Measurement, Control, Regulation and Laboratory
Procedures.
• IEC/EN 61326
"Emission in accordance with requirements for Class A".
Electromagnetic compatibility (EMC requirements)
• NAMUR NE 21:
Electromagnetic compatibility (EMC) of industrial process and laboratory control equipment.
• NAMUR NE 43:
Standardization of the signal level for the breakdown information of digital transmitters with analog output
signal.
• NAMUR NE 53:
Software of field devices and signal-processing devices with digital electronics.
• ANSI/ISA-S82.01
Safety Standard for Electrical and Electronic Test, Measuring, Controlling and related Equipment - General
Requirements Pollution degree 2, Installation Category II.
• CAN/CSA-C22.2 No. 1010.1-92
Safety requirements for Electrical Equipment for Measurement and Control and Laboratory Use.
Pollution degree 2, Installation Category II
FOUNDATION Fieldbus
certification
The flow device has successfully passed all the test procedures carried out and is certified and registered by the
Fieldbus Foundation. The device thus meets all the requirements of the following specifications:
• Certified to FOUNDATION Fieldbus Specification
• The device meets all the specifications of the FOUNDATION Fieldbus H1.
• Interoperability Test Kit (ITK), revision status 5.01 (device certification number: on request)
• The device can also be operated with certified devices of other manufacturers
• Physical Layer Conformance Test of the Fieldbus Foundation
MODBUS RS485 certification The measuring device meets all the requirements of the MODBUS/TCP conformity test and has the "MOD-
BUS/TCP Conformance Test Policy, Version 2.0". The measuring device has successfully passed all the test
procedures carried out and is certified by the "MODBUS/TCP Conformance Test Laboratory" of the University
of Michigan.
PROFIBUS DP/PA
certification
The flow device has successfully passed all the test procedures carried out and is certified and registered by the
PNO (PROFIBUS User Organisation). The device thus meets all the requirements of the following
specifications:
• Certified to PROFIBUS PA, profile version 3.0 (device certification number: on request)
• The device can also be operated with certified devices of other manufacturers (interoperability)
To Next Page
Loading...
