Endress+Hauser Proline Promass 83 - Installation Conditions

To Next Page

To Previous Page

Proline Promass 83 Installation

Endress+Hauser

2.2 Installation conditions

For mechanical reasons, and in order to protect the piping, it is advisable to support heavy

sensors.

2.2.1 Dimensions

For the dimensions of the measuring device see associated Technical Information on the

CD-ROM.

2.2.2 Mounting location

The following mounting locations are recommended:

• Upstream from assemblies such as valves, T-pieces, elbows, etc.

• On the pressure side of pumps (for high system pressure)

• At the lowest point in an ascending pipe (for high system pressure)

The following mounting locations should be avoided:

• At the highest point in a pipe (risk of air accumulating)

• In an open down pipe directly upstream from a free pipe outlet. For ways of using the

measuring device in down pipes, see the related Operating Instructions on the CD-ROM.

Other manuals for Endress+Hauser Proline Promass 83