To Next PageTo Next Page
How to change the language on Endress+Hauser Measuring Instruments display?
If the display texts on your Endress+Hauser Measuring Instruments are in a foreign language, switch off the power supply. Then, press and hold down both the P keys while switching the measuring device back on. The display text will then appear in English (the default language) and will be displayed at maximum contrast.
What to do if Endress+Hauser Measuring Instruments have no display and output signals?
If there is no display visible and no output signals present on your Endress+Hauser Measuring Instruments, follow these steps: 1. Check the supply voltage at Terminals 1 and 2. 2. Check the device fuse. For 85 to 260 V AC, use a 0.8 A slow-blow / 250 V fuse. For 20 to 55 V AC and 16 to 62 V DC, use a 2 A slow-blow / 250 V fuse. 3. If the issue persists, the measuring electronics may be defective.
Why is the display not visible on my Endress+Hauser Measuring Instruments, but output signals are present?
If there is no display visible but the output signals are present on your Endress+Hauser Measuring Instruments, check the following: 1. Ensure that the ribbon-cable connector of the display module is correctly plugged into the amplifier board. 2. If the issue persists, the display module may be defective. 3. If the issue still persists, the measuring electronics may be defective.
What to do if Endress+Hauser Proline Promass 83 display is not visible but connection to FF host system is established?
If there is no display visible on your Endress+Hauser Measuring Instruments, but the connection to the FF host system is established, check the following: 1. Ensure the ribbon-cable connector of the display module is correctly plugged into the amplifier board. 2. If the issue persists, the display module may be defective and require replacement. 3. The measuring electronics could be defective, requiring spare parts.
Why is there no display and no connection to the FF host system on my Endress+Hauser Proline Promass 83 Measuring Instruments?
If there is no display visible and no connection to the FF host system with your Endress+Hauser Measuring Instruments, you should: 1. Check the supply voltage at terminals 1 and 2. 2. Check the device fuse. 3. If neither of these resolves the issue, the measuring electronics may be defective, and you may need to order spare parts.
General| Measuring Principle | Coriolis |
|---|---|
| Application | Liquids, pastes, and slurries |
| Measured Variables | Mass flow, density, temperature |
| Process Temperature | -40 to 150 °C |
| Process Pressure | Up to 40 bar |
| Wetted Materials | Stainless steel |
| Output Signal | 4...20 mA, HART, PROFIBUS DP, FOUNDATION Fieldbus |
| Approvals | ATEX, IECEx, FM, CSA |
| Housing Material | Stainless steel |
| Ingress protection | IP66 / IP67 |
| Ambient Temperature Range | -40 to 60 °C |
| Process connection | Flanged, threaded |
