Endress+Hauser Proline Prosonic Flow B 200 - Page 74

Commissioning Proline Prosonic Flow B 200 HART
74 Endress+Hauser
Parameter Prerequsite Description Selection / User
entry
Factory setting
Failure mode One of the following options is
selected in the Assign
frequency output parameter
(→  72):
• Volume flow
• Corrected volume flow
• Corrected methane volume
flow
*
• Mass flow
• Energy flow
*
• Methane fraction
*
• Wobbe index
*
• Calorific value
*
• Temperature
*
• Sound velocity
• Flow velocity
• Acceptance rate
*
• Signal asymmetry
*
• Turbulence
*
• Signal strength
*
• Signal to noise ratio
*
Define output behavior in
alarm condition.
• Actual value
• Defined value
• 0 Hz
0 Hz
Failure frequency One of the following options is
selected in the Assign
frequency output parameter
(→  72):
• Volume flow
• Corrected volume flow
• Corrected methane volume
flow
*
• Mass flow
• Energy flow
*
• Methane fraction
*
• Wobbe index
*
• Calorific value
*
• Temperature
*
• Sound velocity
• Flow velocity
• Acceptance rate
*
• Signal asymmetry
*
• Turbulence
*
• Signal strength
*
• Signal to noise ratio
*
Enter frequency output value
in alarm condition.
0.0 to 1 250.0 Hz 0.0 Hz
Invert output signal – Invert the output signal. • No
• Yes
No
* Visibility depends on order options or device settings