Endress+Hauser Proline Prosonic Flow B 200 - Page 72

Commissioning Proline Prosonic Flow B 200 HART
72 Endress+Hauser
Parameter overview with brief description
Parameter Prerequsite Description Selection / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output.
• Pulse
• Frequency
• Switch
Pulse
Assign frequency output The Frequency option is
selected in the Operating
mode parameter (→  69).
Select process variable for
frequency output.
• Off
• Volume flow
• Corrected volume
flow
• Corrected methane
volume flow
*
• Mass flow
• Energy flow
*
• Methane fraction
*
• Wobbe index
*
• Calorific value
*
• Temperature
*
• Sound velocity
• Flow velocity
• Acceptance rate
*
• Signal asymmetry
*
• Turbulence
*
• Signal strength
*
• Signal to noise
ratio
*
Off
Minimum frequency value One of the following options is
selected in the Assign
frequency output parameter
(→  72):
• Volume flow
• Corrected volume flow
• Corrected methane volume
flow
*
• Mass flow
• Energy flow
*
• Methane fraction
*
• Wobbe index
*
• Calorific value
*
• Temperature
*
• Sound velocity
• Flow velocity
• Acceptance rate
*
• Signal asymmetry
*
• Turbulence
*
• Signal strength
*
• Signal to noise ratio
*
Enter minimum frequency. 0 to 1 000 Hz 0 Hz