Endress+Hauser Proline Prosonic Flow B 200 - Page 82

Commissioning Proline Prosonic Flow B 200 HART
82 Endress+Hauser
Parameter Prerequsite Description User entry /
Selection
Factory setting
Measuring mode output 2 – Select measuring mode for
output.
• Forward flow
• Forward/Reverse
flow
• Reverse flow
• Reverse flow
compensation
Forward flow
Measuring mode output 2 – Select measuring mode for
output.
• Forward flow
• Forward/Reverse
flow
• Reverse flow
• Reverse flow
compensation
Forward flow
10.4.9 Configuring the low flow cut off
The Low flow cut off wizard guides you systematically through all the parameters that
have to be set for configuring the low flow cut off.
Structure of the wizard
Volume flow
Assign variable
Correct.vol.flow Corr CH4 volflow
Energy flow
Off value
End of wizard
Off
On value
Mass flow
A0015995-EN
 27 "Low flow cutoff" wizard in the "Setup" menu
Navigation
"Setup" menu → Low flow cut off
‣
Low flow cut off
Assign process variable
On value low flow cutoff
Off value low flow cutoff