Endress+Hauser Proline Prosonic Flow B 200 - Page 85

Proline Prosonic Flow B 200 HART Commissioning
Endress+Hauser 85
10.5.1 Configuring the totalizer
In the "Totalizer 1 to 3" submenu the individual totalizer can be configured.
Navigation
"Setup" menu → Advanced setup → Totalizer 1 to 3
‣
Totalizer 1 to 3
Assign process variable
Unit totalizer
Totalizer operation mode
Failure mode
Parameter overview with brief description
Parameter Prerequsite Description Selection Factory setting
Assign process variable – Select process variable for
totalizer.
• Off
• Volume flow
• Corrected volume
flow
• Corrected methane
volume flow
*
• Mass flow
• Energy flow
*
• Off
• Volume flow
• Corrected volume
flow
• Corrected methane
volume flow
• Mass flow
• Energy flow
Volume flow
Unit totalizer One of the following options is
selected in the Assign process
variable parameter (→  85)
of the Totalizer 1 to 3
submenu:
• Volume flow
• Corrected volume flow
• Corrected methane volume
flow
*
• Mass flow
• Energy flow
*
Select process variable totalizer
unit.
Unit choose list Country-specific:
• m³
• ft³