The "Relay/Controls" menu
117
8.4.7 The "pump data" submenu
The most important operating data of the pumps can be displayed in this submenu.
"pump data N" (N = 1 or 2)
(pump selection)
Select a pump from this list. The operating data of this pump will be displayed in the following
parameter set.
"pump data N" (N = 1 or 2)
!
Note!
All pump data displayed in this parameter set are affected by a reset of the Prosonic S.
"operating hours"
Indicates how long the pump has been running since the last reset.
"reset operating hours"
Resets the "operating hours" to 0.
Selection:
• no
"operating hours" keeps its value.
• yes
"operating hours" is reset to 0.
"total operating hours"
Indicates the total time the pump has been running since commissioning. This value can not be
reset.
"number of starts"
Indicates the number of times the pump has been started.
"starts per hour"
Indicates the average number of starts per hour.
"backlash starts"
Indicates the number of times the backlash time has been active for this pump.
⇒
pump data 1 R1610
pump 1:
pump 2:
...
⇒
pump data 1 p 1 R1611
operating hours:
reset operating hours:
total op. hours:
number of starts:
To Next Page
Loading...
