EasyManua.ls Logo

Endress+Hauser Prosonic S FMU90 - Table of Contents

Endress+Hauser Prosonic S FMU90
186 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table of Contents
3
Table of Contents
1 Safety Instructions . . . . . . . . . . . . . . . . 5
1.1 Designated use . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
1.2 Installation, commissioning, operation . . . . . . . . . . . 5
1.3 Hazardous area . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
1.4 Notes on safety conventions and symbols . . . . . . . . . 6
2 Identification . . . . . . . . . . . . . . . . . . . . 7
2.1 Parts of the Prosonic S FMU90 . . . . . . . . . . . . . . . . 7
2.2 Nameplate (Example) . . . . . . . . . . . . . . . . . . . . . . . 8
2.3 Product structure . . . . . . . . . . . . . . . . . . . . . . . . . . 9
2.4 Scope of delivery . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
2.5 Supplied documentation . . . . . . . . . . . . . . . . . . . . 10
2.6 Certificates and approvals . . . . . . . . . . . . . . . . . . . 11
2.7 Registered trademarks . . . . . . . . . . . . . . . . . . . . . . 11
3 Installation . . . . . . . . . . . . . . . . . . . . . 12
3.1 Incoming acceptance, transport, storage . . . . . . . . . 12
3.2 Mounting the field housing . . . . . . . . . . . . . . . . . . 12
3.3 Mounting the DIN-rail housing . . . . . . . . . . . . . . . 14
3.4 Mounting the remote display and operating module 17
3.5 Mounting of the sensors . . . . . . . . . . . . . . . . . . . . 18
3.6 Installation check . . . . . . . . . . . . . . . . . . . . . . . . . 18
4 Wiring . . . . . . . . . . . . . . . . . . . . . . . . 19
4.1 Terminal compartment . . . . . . . . . . . . . . . . . . . . . 19
4.2 Terminal assignment . . . . . . . . . . . . . . . . . . . . . . . 21
4.3 Sensor connection . . . . . . . . . . . . . . . . . . . . . . . . . 24
4.4 Connection of the sensor heater (for FDU91) . . . . . 26
4.5 Connection of external switches
(for FMU90-********B***) . . . . . . . . . . . . . . . . 28
4.6 Connection of a temperature sensor . . . . . . . . . . . . 29
4.7 Shortening the sensor cable . . . . . . . . . . . . . . . . . . 31
4.8 Synchronization line. . . . . . . . . . . . . . . . . . . . . . . 32
4.9 Connection of the separate display and operating
module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
4.10 Potential equalization . . . . . . . . . . . . . . . . . . . . . . 33
4.11 Post-connection check . . . . . . . . . . . . . . . . . . . . . . 34
5 Operation . . . . . . . . . . . . . . . . . . . . . . 35
5.1 Operating options . . . . . . . . . . . . . . . . . . . . . . . . . 35
5.2 Operation via the display and operating module . . . 35
5.3 Operation via Endress+Hauser operating tool
("ToF Tool - Fieldtool Package" or "FieldCare") . . . . 48
5.4 Operation via HART handheld DXR375 . . . . . . . . . 48
5.5 Lock/unlock configuration . . . . . . . . . . . . . . . . . . 49
5.6 Reset to the default configuration . . . . . . . . . . . . . . 50
6 Commissioning. . . . . . . . . . . . . . . . . . 51
6.1 Structure and Functions of the Prosonic S . . . . . . . 51
6.2 First setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 53
6.3 Preparing the basic setup . . . . . . . . . . . . . . . . . . . . 54
6.4 Basic setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55
6.5 Envelope curve display . . . . . . . . . . . . . . . . . . . . . . 71
6.6 After the basic setup . . . . . . . . . . . . . . . . . . . . . . . 71
7 The "display" menu . . . . . . . . . . . . . . 73
7.1 "display" . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 73
7.2 "display format" . . . . . . . . . . . . . . . . . . . . . . . . . . . 75
7.3 "back to home" . . . . . . . . . . . . . . . . . . . . . . . . . . . 75
8 The "Relay/Controls" menu . . . . . . . . 76
8.1 Configuration of a limit relay . . . . . . . . . . . . . . . . . 76
8.2 Configuration of an alarm or diagnostic relay . . . . . 81
8.3 Configuration of a pump control - standard . . . . . . 83
8.4 Configuration of a pump control - enhanced . . . . . . 96
8.5 Configuration of a rake control . . . . . . . . . . . . . . . 122
9 The "output/calculations" menu. . . . 127
9.1 The "allocation/calculations" submenu . . . . . . . . . 128
9.2 The "extended calibration" submenu . . . . . . . . . . 129
9.3 "HART settings" submenu
(only for current output 1) . . . . . . . . . . . . . . . . . . 132
9.4 "Simulation" submenu . . . . . . . . . . . . . . . . . . . . . 134
10 Troubleshooting . . . . . . . . . . . . . . . . 135
10.1 System error messages . . . . . . . . . . . . . . . . . . . . . 135
10.2 Possible calibration errors . . . . . . . . . . . . . . . . . . . 139
10.3 Envelope curve display . . . . . . . . . . . . . . . . . . . . . 140
10.4 Software history . . . . . . . . . . . . . . . . . . . . . . . . . . 143
11 Maintenance and repairs . . . . . . . . . . 144
11.1 Exterior cleaning . . . . . . . . . . . . . . . . . . . . . . . . . 144
11.2 Repairs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 144
11.3 Repairs to Ex-approved devices . . . . . . . . . . . . . . 144
11.4 Replacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . 144
11.5 Replacing a sensor . . . . . . . . . . . . . . . . . . . . . . . . 144
11.6 Spare parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 145
11.7 Return . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 151
11.8 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 151
11.9 Contact addresses of Endress+Hauser . . . . . . . . . . 151
12 Accessories . . . . . . . . . . . . . . . . . . . . 152
12.1 Commubox FXA191 HART . . . . . . . . . . . . . . . . . 152
12.2 Commubox FXA195 HART . . . . . . . . . . . . . . . . . 152
12.3 Commubox FXA291 . . . . . . . . . . . . . . . . . . . . . . 152
12.4 Protection cover for the field housing . . . . . . . . . . 152
12.5 Mounting plate for the field housing . . . . . . . . . . . 153
12.6 Mounting bracket . . . . . . . . . . . . . . . . . . . . . . . . 153
12.7 Adaption plate for remote display . . . . . . . . . . . . . 154
12.8 Overvoltage protection (in IP66 housing) . . . . . . . 154
12.9 Overvoltage protection HAW56x . . . . . . . . . . . . . 155
12.10 Extension cable for sensors . . . . . . . . . . . . . . . . . 158
12.11 Temperature sensor FMT131 . . . . . . . . . . . . . . . . 159

Table of Contents

Other manuals for Endress+Hauser Prosonic S FMU90

Related product manuals