Wiring
23
#
Warning!
When using the public supply mains, an easily accesible power switch must be installed in the
proximity of the device. The power switch must be marked as a disconnector for the device (IEC/
EN 61010)
!
Note!
• In order to avoid interference signals, the sensor cables should not be laid parallel to high voltage
or electric power lines.
• The cables may not be laid in the proximity to frequnecy converters.
Additional elements on the terminal areas
#
Warning!
On wiring, the supply voltage must be switched off.
1) In this case, terminals 9/10/11 are not present on terminal area A.
Designation Meaning/Remarks
Fuse Fuse: 2 A T /DC or 400 mA T/AC
Display Connection of the display or the remote display and operating module
Service Service interface for connection of a PC/Notebook via Commubox FXA291
Locking switch
Term. Bus termination (only applicable for instruments with PROFIBUS interface)
Address Bus address (only applicable for instruments with PROFIBUS interface)
To Next Page
Loading...
