Endress+Hauser Prothermo NMT81 - Simulation

Diagnostics and troubleshooting Prothermo NMT81
100 Endress+Hauser
11.3.4 Simulation
This is to generate an error deliberately and verify how the output appears in a simulation.
Simulation has two parameters to be set in the Simulation pull-down menu. Normally set
to Off.
A0045019
 104 Simulation screen
• Current output: Sets current output to other than 4 mA.
• Diagnostic event simulation: Selects the error code to verify how the output appears. For
details of error codes, →  92
11.3.5 Diagnostic settings
Diagnostic settings has two items to be confirmed and set.
Properties
A0045020
 105 Properties screen
The following can set the delay time of the alarm between 0 to 60 sec..