Applications
Number of measurement points
The number of measurement points vary according to the unit model and application. For further
details, please see the table for applications/measurement points.
In general, the following measurements are possible:
Up to 3 measurement points with the input values (measurements) q, T.
Two measurement points are covered by the basic unit. Expansion cards are required if further
measurement points are to be added. Each expansion card is fitted with outputs
(analogue/impulse) for retransmission of process values. Relay outputs are also available.
Diagram/calculation formula
T q
E = q (T, p) h (T)
E: Heat quantity
q: Operating volume
: Density
T: Operating temperature
p:
Average operating pressure
h: Specific Enthalpy of water
To Next Page
Loading...
