Operating the Analyzer
Operator’s Manual 2
–27
Operator Password
The Operator Password parameter enables or disables a password
requirement for entering the Operator Parameter section. Enter 0 for a
password to disable a password requirement, or a positive value (up to four
digits) to require a password. If 0 is used, accessing the Operator Parameter
section requires only pressing the # key followed by the 2 key (to enter Mode
Table 2–4 Operator Parameters
Parameter Index Index
Validation Wait Time 24 Modbus Mode 108
High Alarm Setpoint 27 Low Alarm Setpoint 121
Logger Rate 28 AO 4-20 mA Test 128
Temperature Unit 29 4-20 mA Val Action 130
Pressure Unit 30 Calculate Dew Point 131
Concentration Unit 31 Pipeline Pressure 132
Val 1 Concentration 33 Dew Point Method 133
Validation Allowance 34 AO 4 mA Value 134
Cancel Val Alarms 35 AO 20 mA Value 135
Set Time - Year 36 AI Pressure Input 148
Set Time - Month 37 AI 4 mA Value 149
Set Time - Day 38 AI 20 mA Value 150
Set Time - Hour 39 Zero Val Tolerance 159
Set Time - Minute 40 DO Alarm Setup 168
Val Start Time 41 Val Interval 169
4-20 mA Alarm Action 64 Val Attempts 178
General Alarm DO 65 2-Way Com Port 184
Baud Rate 66 ValPerm Constant Kp 186
Start Validation 71 ValPerm Rate Rp 187
Daily Validation 72 Keypad Watchdog 189
RATA 75 Custom Precision 204
RATA Multiplier 76 Peak Tracking 219
RATA Offset 77 Val 2 Concentration 223
Val Auto DumpSpectrm 100 Update RATA 225
Modbus Address 107 Operator Password 226
To Next Page
Loading...
Need help?
General
