Endress+Hauser SpectraSensors SS2100 - Mode 8: (Measure Port2 Mode); Mode 9: (Recall Validation Results)

NS 5.14 Firmware
2–8 4900002262 rev. B 3-23-21
Mode 8: (Measure Port2 Mode)
Mode 8 switches the analyzer to measure validation gas supply #2. Press the
# key followed by the 8 key.
Returning to Mode 1 re-establishes normal operation measuring process gas.
Mode 9: (Recall Validation Results)
Mode 9 recalls the measured value from the last autovalidation cycle on units
with autovalidation capability. Press the # key followed by the 9 key.
For systems not set up for a validation, the following screen displays:
For systems set up for a single validation, the following screens may be
displayed:
a. If an automatic validation or Mode 7 has not yet been
processed:
+
#
8
<MEASURE PORT2 MODE>
ANA: 4.0256ppmv
P: 954.4mb T: 76.1F
+
#
9
<VALIDATION RESULTS>
No Validations
Are Defined
<VALIDATION RESULTS>
Date: 17-04-10 13:00
1: NO DATA