NS 5.14 Firmware
4–8 4900002262 rev. B 3-23-21
– Start Character: If Active Connect is set to With Start
Character, enter the start character in this field.
– Modem Mode: Indicates the on-screen response type when
in Modem Mode (if Modem Mode is enabled).
– Show IP Address After Ring: Indicates whether to display
the remote IP address upon connection. The default setting is
Yes.
• Endpoint Configuration
– Local Port: Enter the local port number.
– Auto increment for active connect: Select to auto-
increment the local port number for new outgoing
connections. The range of auto-incremented port numbers is
50,000 to 59,999 and loops back to the beginning when the
maximum is reached.
– Remote Port: Enter the remote port number.
– Remote Host: Enter the IP address of the remote device.
• Common Options
– Telnet Com Port Cntrl: This field is available for
configuration only when Active Connect is set to None.
Select Enable to permit Telnet communication to the unit.
The Telnet Com Port Cntrl feature is used in conjunction
with the Com Port Redirector (CPR) utility. Refer to the CPR
online Help for details.
– Terminal Name: This field is available for configuration only
when Telnet Mode is set to Enable.
Use the terminal name for the Telnet terminal type. Enter
only one name. When this option is enabled, the unit also
reacts to the end of record (EOR) and binary options, which
can be used for applications such as terminal emulation to
IBM hosts.
– Connect Response: A single character is transmitted to the
serial port when there is a change in connection state. The
default setting is None.
– Use Hostlist: If this option is set to True, the device server
scrolls through the host list until it connects to a device listed
in the host list table. Once it connects, the unit stops trying to
To Next Page
Loading...
Need help?
General
