230922001-J0 Rev A
Cordex® CXPS-E105 Edge Power Systems
User Guide
5. Inspection
5.1 Packing materials
Alpha Technologies Ltd. is committed to providing products and services that meet our customers’ needs and
expectations in a sustainable manner, while complying with all relevant regulatory requirements. As such Alpha
strives to follow our quality and environmental objectives from product supply and development through to the
packaging for our products.
Rectifiers and batteries are shipped on individual pallets and are packaged according to the manufacturer’s
guidelines.
Almost all Alpha Technologies Ltd. packaging material is from sustainable resources and or is recyclable.
5.2 Returns for service
Save the original shipping container. If the product needs to be returned for service, it should be packaged in its
original shipping container. If the original container is unavailable, make sure that the product is packed with at
least three inches of shock-absorbing material to prevent shipping damage.
5.3 Check for damage
Before unpacking the product, note any damage to the shipping container. Unpack the product and inspect the
exterior for damage. If any damage is observed, contact the carrier immediately. Continue the inspection for any
internal damage. In the unlikely event of internal damage, inform the carrier and contact Alpha Technologies Ltd.
for advice on the impact of any damage.
5.4 General receipt of shipment
The inventory included with your shipment depends on the options you have ordered. The options are clearly
marked on the shipping container labels and bill of materials.
5.5 Miscellaneous small parts
Review the packing slip and bill of materials to determine the part number of the configuration kits included with
your system. Review the bill of materials to verify that all the small parts are included. Contact us if you have any
questions before you proceed.
NOTICE
Alpha Technologies Ltd. is not responsible for damage caused by improper packaging of
returned products.