EnerSys alpha Cordex CXPS-E105 User Manual

410922001-J0 Rev A
Cordex® CXPS-E105 Edge Power Systems
User Guide
5. Discard the old fan assembly and unpack the new replacement assembly.
6. Reconnect the fan cable. Insert the connector into the fan connector in the module. Ensure proper polarity
and that the wires stay clear of the fan blade.
7. Slide the front panel into the rectifier body.
8. Ensure the metal tabs of the rectifier body aligned with the screw holes of the front panel.
9. Ensure the plastic tabs of the front panel are protruding through the metal cutouts in the rectifier body.
10. Secure the front cover by hand tightening the bottom screws.
10.2 Batteries
It is recommended that checks are made every six months for battery voltage, conductance, temperature,
impedance, and connections. See the battery manufacturer's documentation for general maintenance
information. Depress the two front latches and tilt the front panel forward and down. Remove the battery from
the slot and replace with the same type of battery observing the correct polarity.

EnerSys alpha Cordex CXPS-E105 Specifications

General

Brand	EnerSys
Model	alpha Cordex CXPS-E105
Category	Power Supply
Language	English