Management VLAN (Only applicable in Access Point mode)
Restricted client to communicate with different VID by selecting the radio button.
Specify the VLAN tag for each profile.
If your network includes VLANs, you can specify a VLAN ID for packets pass through the Access
Point with a tag. Otherwise, select No VLAN tag.
Click Accept to confirm the changes or Cancel to cancel and return previous settings.
Note:
1. If you reconfigure the Management VLAN ID, you may lose your connection to the EAP600. Verify that the DHCP server supports the
reconfigured VLAN ID and then reconnect to the EAP600 using the new IP address.
2. Clicking Accept does not apply the changes. To apply them, use Status > Save/Load (see section 5.1).
To Next Page
Loading...
