Enovation Controls Murphy PowerView PV485 User Manual

2021-0306-2507 38 00-02-1207
Modbus Parity
This menu item allows the operator to set the Parity for the Modbus communication.
Default to None
None
Odd
Even
Modbus Slave Address
This menu item allows the operator to set the Slave Address for Modbus
communication. Default to 1.
CAN Baud Rate
This menu item allows the operator to set the Baud Rate for CAN communication.
Default to 250Kbps
10 Kbps
20 Kbps
50 Kbps
100 Kbps
125 Kbps
250 Kbps
500 Kbps
800 Kbps
1 Mbps
CAN Termination Resistor
Allows the operator to enable or disable the display’s internal 120 ohm terminating
resistor. This should be enabled if the display is located at the end of the CANbus and
there is no end-terminating resistor on the harness. Factory set to
Enable.
Diagnostics
This menu section provides the operator diagnostics tools to aid in
troubleshooting.
• IO status
• Modbus Register
• TX CAN Live Watch
• RX CAN Recorder
• DM1 Logger
• Stored ECU Fault Codes

Enovation Controls Murphy PowerView PV485 Specifications

General

Brand	Enovation Controls
Model	Murphy PowerView PV485
Category	Monitor
Language	English