IQ7+ and I Q7A Installation and Operation Manual – India
5 © 2023 Enphase Energy Inc. All rights reserved. August 2023
USM-00002-1.0
Important safety information
Read this first
This manual contains important instructions for use during the installation and maintenance of the IQ7 Series
Microinverters.
IMPORTANT: Enphase IQ Series Microinverters require the IQ Cable and are not compatible with previous
Enphase cabling. An IQ Gateway Metered is required to monitor the performance of the IQ Microinverters. The
IQ accessories work only with Enphase IQ Series Microinverters.
Product labels
The following symbols appear on the product label and are described here:
WARNING: Hot surface
DANGER: Refer to safety instructions
DANGER: Risk of electrical shock
Refer to the manual
Double insulated
Safety and advisory symbols
To reduce the risk of electric shock and to ensure the safe installation and operation of the Enphase IQ System,
the following safety symbols appear throughout this document to indicate dangerous conditions and
important safety instructions.
DANGER
:
indicates a hazardous situation, which, if not avoided, will result in death or
injury.
WARNING:
indicates a situation where failure to follow instructions may be a safety hazard
or
cause equipment malfunction. Use extreme caution and follow instructions carefully.
WARNING:
indicates a situation where failure to follow instructions may result in a burn
NOTE:
indicates information that is very important for optimal system operation. Follow
the instructions closely.
IQ7 Series Microinverter safety instruction
safety
DANGER: Risk of
electric shock. Risk
of fire.
use electrical system components approved for wet locations.
Only qualified personnel should install, troubleshoot, or replace
Enphase
microinverters or Enphase IQ Cable and accessories.
Ensure that all AC and DC wiring is correct and that none of the AC or DC wires
are pinch
ed, shorted, or damaged. Ensure that all AC junction boxes are properly
To Next Page
Loading...
