SQ-80 — Musician's Manual
ow select Track 2, and the Page looks like this:
The Program from Track 1 was "carried over
-
and assigned to Track 2 when it was selected. Selecting
an UNUSED Track automatically assigns that Track the Program, and all the Mix
•
MIDI Data,
from the previously selected Track (or the "Straight Synth" Program and MIDI Channel. if no
Track was selected).
Whenever a Track is selected:
1) Its Program becomes the Current Program, the one that plays on the Keyboard;
2) Its MIDI Channel
(Mix
•
MIDI Page) will be transmitted on;
3) That Track (and only that Track) is the one that will be Recorded when
Record is entered:
4) That Track is the one that will be Edited when any of the
Track EDIT functions is selected from
the
EDIT Page.
Changing the Program on a Track
The procedure for choosing a Program for a Track is similar to that for choosing a WRITE location. or
a
LAYER Program. While you are on the Track Select Page. the Program Master Bank and Bank
Select Buttons act as momentary switches — they only work as long as they are held down. Let them
go and the Display springs back to the
Tracks Select Page.
The procedure for selecting a Local Program for a Track is as follows:
____ > Select
Tracks Select Page.
> Select one of the eight
Tracks.
− Press
INTERNAL, CART A or CART B to select a Master Bank.
− > Press
Bank Select Button(s) # 1, 2, 3 or 4 to find the Program you want.
− While holding the Bank Select Button down, press the "Soft" Button above or below the Program.
− > Release the Bank Select Button. You will be returned to the Tracks Select Page, with the
new Program Name showing in the selected Track's location.
Section 4 — The Sequencer
95
To Next Page
Loading...
