SQ-80 — Musician's Manual
> UPPER — When SPLIT=UPPER is selected, the Split Program (see #8) will play on the Uppe
Keyboard (that is, above the Split Key), and the Current Program will play on the Lower
Keyboard (below the Split Key).
> LOWER — When SPLIT=LOWER is selected, the Split Program will play on the Lower
Keyboard (that is, below the Split Key), and the Current Program will play on the Upper
Keyboard (above the Split Key).
So when you select UPPER or LOWER here, you are selecting which area of the
Keyboard the
Split Program will occupy. The Current Program (the one you started from) will
always occupy the the opposite Keyboard half.
8. Select SPLIT Program
The Program whose name appears here will occupy the half of the Keyboard as designated above
(#6), if
SPLIT=UPPER or SPLIT=LOWER has been selected.
When this control is selected (Underlined), you can choose a new
SPLIT Program in one of two
ways:
• Use the
Data Entry Slider and the Up and Down Arrow Buttons to scroll through the
various Programs in Memory until you find the one you want; or
• Press
Internal, CART A, or CART B to select a Master Bank, then press one of the fou
Bank Select Buttons and, while holding it down, select the Program you want. You will be
returned to the
Split/Layer Page with the new Program selected as the SPLIT Program.
Note: Whenever you select a Layer Program, a Split Program, or a Split/Layer Program, the SQ-
80
only "remembers" the Location of that Program in Internal or Cartridge Memory — not the
Program itself. If you move a Program, put another in its place, or transfer an entire Bank o
Programs, the Layer. Split, or Split/Layer Program on this Page might still be "pointing to" a
Location that no longer contains the sound you had in mind.
Section 3 — Voice Programming 73
To Next Page
Loading...
Need help?
General
