SQ-80 — Musician's Manual
2.7.2 Device ID Message
When the SQ-80 receives a correctly formatted MIDI Device Inquiry message it will respond with the following
Device ID Message. This message follows the MMA recommendations for device ID messages, and contains
information about the responding device including manufacturer, product family and software revision.
11110000 System Exclusive Status byte
01111110 Non real time message
0000nnnn nnnn=Base MIDI Channel
00000110 General Information message code
00000010 Device ID Message code
00001111 ENSONIQ System Exclusive manufacturer's code
00000010 ESQ/SQ-80 Product Family code (Isb)
00000000 ESQ/SQ-80 Product Family code (msb)
00000011 SQ-80 Family Member code (lsb)
00000000 SQ-80 Family Member code (msb)
00000000 Software revision information
00000000
Onnnnnnn Major Version number (integer portion)
Onnnnnnn Minor version number (decimal fraction)
11111110 End of Exclusive
2.8 ESQ-1 Sequence Messages Received
These ESQ-1 Sequencer Messages are received and understood by the SQ-80 but not transmitted.
2.8.1 ESQ-1 All Sequence Dump Alert
This message is transmitted by the sending ESQ-1 to inform the receiving unit that it wishes to dump the
entire sequencer memory.
xxxxxxxx ESQ/SQ-80 System Exclusive Header
00000011 ESQ-1 All Sequence Dump Alert code
0000LLLL
0000LLLL Low byte (in nybbles) of sequence size
0000hhhh
0000hhhh High byte (in nybbles) of sequence size
11110111 End of exclusive
2.8.2 ESQ-1 All Sequence Dump Packet
This packet contains the sequence data. The data block consists of 132H bytes of track and pointer information,
followed by the number of bytes of sequence data, as determined by the sequence size specified in the All
Sequence Dump Alert packet. (see 2.8.1).
196 SQ-80 MIDI Implementation Specification
To Next Page
Loading...
