ENSONIQ SQ-80 - Page 8

SQ-80 — Musician's Manual
20 .........................PEDAL — Foot Pedal Function Select
20 ........................ Pitch Bend Range
20 ........................ Pitch Bend Mode
21 ..................MIDI Page
22 .........................CHAN— Base MIDI Channel
22 .........................OVFL — MIDI Overflow Mode
22 .........................XCTRL — Select External Controller
23 .........................PRESS — Pressure (Aftertouch) Control
24 .........................MODE — Select MIDI Mode
26 .........................ENABLE — MIDI Enables
SECTION 3 — Voice Programming
28 ...................Voice Diagram — an SQ-80 Voice
29 ...................About
CrossWaveTM
Synthesis
30 ...................WAVES
30 .........................Digital Wave Memory
30 .........................Waveforms, Inharmonic Loops and Transient
Attacks
32 ........................ Synthetic, Sampled and Multisampled Waves
32 .........................Names
32 ........................Selecting a Wave for Each Oscillator
33 ........................Check Them Out
33 .........................The Waves
40 ...................MODULATORS
40 .........................About Modulation
40 ........................ Selecting a Modulator
41 ........................ Modulation Depth
41 ........................ Modulation Sources
45 ........................ Using Modulators
47 ...................PROGRAMMING PAGES
48 .........................OSC 1-3 — Oscillator Pitch Pages
50 .........................DCA 1-3 — Oscillator Volume Pages
52 ........................ FILTER Page
54 .........................DCA 4 — Final Volume Page
56 .........................LFO 1-3 — Low Frequency Oscillators
59 ......................... Understanding the Envelopes
65 .........................ENV 1-4 — Envelope Pages
68 .........................MODES Page
71 ........................ SPLIT/LAYER Page
75 ...................Programming Conventions
76 ...................WRITE Page
76 ........................ Saving a New Program into Memory
78 .........................Copying an Existing Program to Another Location
vi Table of Contents