Section 9 — Program Parameters TS-12 Musician’s Manual
38
Copy Drum-Map Parameters
Pressing Copy from the Drum-Map Editor page will display the Copy page:
The MAKE COPY option allows you to make a copy of the complete Drum-Map from the
currently selected program (or the Compare Buffer) into the Copy Buffer.
The RECALL option allows you to recall the complete Drum-Map from the Copy Buffer into an
edited version of the current program if 1) the current program has a Drum-Map installed in it
and 2) the Copy buffer contains a Drum-Map. If you attempt to recall a Drum-Map into a
program without just previously having copied a Drum-Map into the Copy buffer, the copy is
not completed and the following message is displayed:
Selecting the KEY RANGE option will display another page which allows you to fill a range of
keys with copies of the currently selected Drum-Map key (the key that was shown on the Drum-
Map Editor page when you pressed Copy).
KEY–RANGE START / END Ranges: B1 to B6
Allows you to specify the range of keys in the drum-map to be filled by playing the lowest and
then highest key of the range. You can also edit these parameters using the Data Entry Slider or
the Up/Down Arrow buttons. Press the soft button to select between the Start and End key
fields.
Selecting *COPY* will complete the command and will show COPY DONE before returning to
the Copy page.
Selecting *EXIT* will simply return the Copy page without affecting the Drum-Map.
To Next Page
Loading...
Need help?
General
