EasyManuals Logo

ENSONIQ TS-12 User Manual

ENSONIQ TS-12
445 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #302 background imageLoading...
Page #302 background image
Section 10 — Understanding the Sequencer TS-12 Musician’s Manual
34
If external sync is being used (CLOCK=MIDI), recording begins with the first clock received after
the MIDI Start command. If internal sync is selected (CLOCK=INT), then recording begins when
the first note is received.
Note: With the SQX-70 installed, the sequencer can record over 97,00 notes. However the sequencer
record buffer is of a limited size, and can only record 16, 00 notes at one time. As a result, you
may see an OUT OF MEMORY message if you exceed the size of the record buffer. (this is most
common in multi-track record). If this occurs, try editing the incoming data into several smaller
sequences; then, once recorded into the TS-12 sequencer, append them together.
Basic Multi-track Recording from an External Sequencer
The following procedure is the basic method for recording a multi-track sequence from an
external sequencer into the TS-12.
Set MODE=MULTI on MIDI Control page.
Set CLOCK=MIDI and REC-SOURCE=MULTI on the Sequencer Control page(s).
Disable count-off on both systems to avoid problems.
Disable sequence looping on the external sequencer.
Create a new sequence with the correct time signature.
Make sure that the external sequencer will send its track data on MIDI channels that the TS-12
is set up to receive (track MIDI channels 1..12 by default).
Make sure that the external sequencer will send program changes at the start of each track to
automatically define the necessary tracks on the TS-12, or define them yourself on the TS-12
manually.
Press Record to enter MIDI Record mode (MREC will be flashing indicating that the TS-12 is
waiting for MIDI Start and Clock messages).
Start your external sequencer playing its sequence. When the external sequence stops, or
when you press Stop on the TS-12, the TS-12 will show “EDITING DATA...” for a time and
then display the Locate page.
Set CLOCK=INT on the Sequencer Control page and press Play to hear what you have
recorded. You may then decide that the results are satisfactory, or if not, you can try again or
erase the sequence.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ENSONIQ TS-12 and is the answer not in the manual?

ENSONIQ TS-12 Specifications

General IconGeneral
BrandENSONIQ
ModelTS-12
CategorySynthesizer
LanguageEnglish

Related product manuals