TS-12 Musician’s Manual Section 10 — Understanding the Sequencer
35
Recording into the Sequencer in a MIDI Loop
Use the following basic procdure if you want to record into the TS-12’s sequencer from its own
keyboard in a MIDI loop. You can record to a single track, or to multiple stacked tracks,
depending on which tracks are selected, and how you set the REC-SOURCE parameter on the
Sequencer Control page:
• Set MIDI-TRK-NAMES=ON on the System page.
• Set MODE=MULTI, LOOP=ON, START/STOP=OFF and PROG-CHG=OFF all on the MIDI
Control pages.
• Set REC-SOURCE=MIDI (to record onto a single track with Audition) or REC-
SOURCE=MULTI (to record onto multiple stacked tracks with no Audition) on the Sequencer
Control page.
• Enter Seqs/Songs mode and create a new Sequence. Select and define all 12 tracks.
• Set the Track STAT (Status) to MIDI-LOOP for all 12 tracks.
• Set each of the tracks to a discrete MIDI channel (we recommend assigning tracks 1-12 to MIDI
channels 1-12 to avoid confusion).
• Connect the MIDI Out jack of the TS-10 to the MIDI In jack of the TS-10 with a single MIDI
cable.
• Select or stack the track(s) that you want to record on. Playing the keyboard will transmit out
the MIDI Out jack, back in the MIDI In jack, and will play the sounds that are assigned to the
selected and stacked tracks.
• Enter record as usual. If REC-SOURCE=MIDI, data will only be recorded on the primary
(solidly selected) track, and any stacked tracks will be de-selected after Audition. If REC-
SOURCE=MULTI, data wil be recorded on all selected and stacked tracks, but there will be no
Audition.
To Next Page
Loading...
Need help?
General
