Built-in Commands
Network Tools Screens 11-11
link_trap
Description: Allows link traps to be enabled or disabled when specifying a single port, or
simultaneously when specifying “all” or no ports. When one or all ports are
specified to enable, disable, or find their status, their current condition is
displayed.
Syntax: link_trap [enable/disable/status] <PORT/all>
Options: None
Example:
-> link_trap status
LINK TRAP STATUS:
Port 1 is ENABLED Port 2 is DISABLED
Port 3 is ENABLED Port 4 is ENABLED
-> link_trap disable 2
Link traps have been DISABLED on port 2
-> link_trap disable all
Link traps have been DISABLED on all ports (1-24)
-> link_trap status 3
Link traps are ENABLED on port 3
To Next Page
Loading...
