Built-in Commands
11-10 Network Tools Screens
soft_reset
Description: Restarts the software image, which restores the user configuration settings
from NVRAM. The user will be queried to confirm the reset command to
ensure against unwanted resets.
TIP: The Network Tools connection to the device will be terminated
upon execution of this command.
Syntax: soft_reset
Options: None
Example:
->soft_reset
RESET: Are you *SURE* ? -> Y
telnet
Description: Allows the user to communicate with another host (that supports Telnet
connections) using the Telnet protocol. The user must specify the remote host
using its IP address. The [IP address] field is mandatory. If no Port number is
specified, telnet will attempt to contact the host at the default port.
Syntax: telnet [IP address] <Port #>
Options: None
Example:
-> telnet 134.141.12.345
Trying 134.141.12.345
Connected to 134.141.12.345
SunOS UNIX (server 1)
login:
To Next Page
Loading...
