Enterasys 2H25x - Page 258

Built-in Commands
11-22 Network Tools Screens
Options: radius
Shows Radius help
radius status
Shows all Radius client settings
radius [enable | disable]
Enables or disables the Radius Client
radius prim_ip <server ip>
Shows <sets> the primary Radius server’s IP, in decimal-dotted format
radius sec_ip <server ip>
Shows <sets> the secondary Radius server’s IP, in decimal-dotted format
radius timeout <n>
Shows <sets> Radius server timeout in seconds
radius retry <n>
Shows <sets> number of Radius server retries
radius clear
Resets all Radius client settings
radius prim_auth_port <n>
Shows <sets> the primary Radius server’s UDP authentication port
radius sec_auth_port <n>
Shows <sets> the secondary Radius server’s UDP authentication port
radius prim_acct_port <n>
Shows <sets> the primary Radius server’s UDP accounting port
radius sec_acct_port <n>
Shows <sets> the secondary Radius server’s UDP accounting port
radius last_resort < [local|remote] [accept|reject|challenge] >
Shows <sets> the last-resort action to take if all radius servers timeout, for
either local (COM port) or remote (TELNET) sessions:
Accept – accept user with no further authentication
Reject – reject user unconditionally
Challenge – challenge the user for the system password (i.e., revert to
legacy module passwords)
radius (Continued)