Enterasys 2H25x - Page 259

Built-in Commands
Network Tools Screens 11-23
Options:
(Continued)
radius prim_secret
Sets the primary Radius server’s shared secret.
radius sec_secret
Sets the secondary Radius server’s shared secret.
NOTE: The secret is NOT encrypted in transit; if this command is
sent via TELNET then the secret may be compromised.
For maximum security, it is recommend to use a 16 to 32 character
string for the shared secret code. For security reasons, the entered
code appears as asterisks (*) on the screen.
Example:
-> radius client
RADIUS Configuration Cli
Command Format : radius
status (shows Radius status)
clear (clears all entries)
timeout (server timeout, seconds)
last_resort <local|remote>
<accept|reject|challenge>
retry <number of retry attempts>
enable (enables radius client)
disable (disables radius client)
prim_secret (sets primary secret)
prim_ip <primary server IP>
prim_auth_port <primary server authentication port>
prim_acct_port <primary server acct port>
sec_secret (sets secondary secret)
sec_ip <secondary server IP>
sec_auth_port <secondary server authentication port>
sec_acct_port <secondary server acct port>
->
radius (Continued)