Enterasys SecureStack B2 B2G124-24 - Management; Switch Configuration Using Webview; Switch Configuration Using CLI Commands; Standards Compatibility

Management
SecureStack B2 Installation Guide 1-7
Management
Managementofthemodulecanbeeitherin‐bandorout‐of‐band.In‐bandremote
managementispossibleusingTelnet,Enterasys Networks’NetSight
®
management
application,ortheWebViewapplication.Out‐of‐bandmanagementisprovidedthrough
theDB9ConsoleportconnectoronthefrontpanelusingaVT100terminaloraVT100
terminalemulator.
Switch Configuration Using WebView
Enterasys Networks’HTTP‐basedWebmanagementapplication(WebView)isan
intuitivewebtoolforsimplemanagementtasks.
Switch Configuration Using CLI Commands
TheCLIcommandsenableyoutoperformmorecompleteswitchconfiguration
managementtasks.
ForCLIcommandsetinformationandhowtoconfigurethemodule,refertothe
SecureStackB2ConfigurationGuide.
Standards Compatibility
The1000BASE‐Tports arecompliantwiththefollowing standardsandoperations:
• IEEE802.3
• IEEE802.3u
• IEEE802.3ab
•Full‐Duplexoperation
TheSFPportsarecompliantwiththefollowingstandardsandoperations:
• IEEE802.3z
• IEEE802.3xFlowControlsupportforFull‐Duplexmode
•Auto‐negotiationforFull‐Duplexcontroloperations
LANVIEW Diagnostic LEDs
LANVIEWdiagnosticLEDsserveasanimportanttroubleshootingaidbyprovidingan
easywaytoobservethestatusofindividualportsandoverallnetworkoperations.