Entes RG3-12C - Page 10

POWER FACTOR CONTROLLER
RG3-12C/CS
9
3.5.b Switch-Off Delay Time Setting
Press the SET button to enter delay time settings menu(dELy).
The first setting in this menu is the switch on delay time setting(t-
on). Press theSET button to change this time value.
Enter a value between 1-1800 seconds and then press SET
button. Using the UP/DOWN buttons, enter to another menu
option which you wish to change. If you are not going to change
any more settings, press the ESC button.
SAUE
If you want to leave the setup menu without making any other
changes, press the ESC button until SAVE SEt yES shows
on the screen. If you want to save the changes, press the SET
button. If not, press the ESC button.
Switch-off delay time must be set according to system requirement in
order to achieve compensation targets and also to provide long life time
for contactors and capacitors.
Using the UP/DOWN buttons, select the switch-off delay time
(dELy t-oF) menu.
Press theSET button to change this time value.
SAUE
If you want to leave the setup menu without making any other
changes, press the ESC button until SAVE SEt yES shows
on the screen. If you want to save the changes, press the SET
button. If not, press the ESC button.
Enter a value between 1-1800 seconds and then press SET
button. Using the UP/DOWN buttons, enter to another menu
option which you wish to change. If you are not going to change
any more settings, press the ESC button.