Entes RG3-12C - Page 23

POWER FACTOR CONTROLLER
RG3-12C/CS
22
Press the SET button to enter the fan switch on temperature value.
Enter the temperature alarm between 00.0-99.8 °C and press the SET
button.
If you are going to change another setting, return to the menu by
pressing the SET button.
If you do not want to set another parameter,
press the ESC button.
SAUE
If you want to leave the setup menu without making any other changes,
press the ESC button until SAVE SEt yES shows on the screen. If
you want to save the changes, press the SET button. If not, press the
ESC button.
3.10.b Switch Off Value for Fan Relay
Fan relay switching off temperature is programmed in this menu.
The first parameter in the Fan menu(FAn) is the operating temperature of
the fan. Press SET button to enter the operating temperature settings.
Press the SET button to program the switch off value for the
fan relay.
Press SET button to enter the temperature alarm between
00.0-99.8 °C(A higher value than FAn on value can not be
programmed).
If you are going to change another setting, return
to the menu by pressing the SET button.
If you do not want to
set another parameter, press the ESC button.
SAUE
If you want to leave the setup menu without making any other changes,
press the ESC button until SAVE SEt yES shows on the screen. If
you want to save the changes, press the SET button. If not, press the
ESC button.
Using the UP/DOWN buttons, find FAn oFF menu which is the second
setting in the fan relay menu.