57
IP1967EN - 2016-08-01
Display Description
SR - Transmitter memory storage.
...x2, x3...
ER - Deleting a single transmitter.
2 s
EA - Total memory deleting.
2 s 2 s
EC - Deleting a single code. (FUTURE USE)
RE - Setting memory opening from remote control.
When enabled (ON) remote programming is activated. To
memorise new transmitters without using the control panel,
press and hold down the PRG key of an already-memorised
GOL4 transmitter for 5 seconds until the LED switches on
(within the capacity of the receiver) and press any CH key of
the new transmitter.
NOTE: make sure that undesired transmitters are not acci-
dently memorized.
OFF ON
MU - Setting the maximum number of transmitters that
can be memorized on a memory module.
It is possible to memorise up to 100 or 200 rolling code
transmitters.
200 100
- use the keys S and T to select the required function
- press the ENTER key to confirm
9.7 Second level menu - RO (Radio Operations)
It is possible to directly access the Transmitter memory storage menu with the di-
splay switched off, but only with Display visualization mode set at 00 or 03:
- by transmitting a remote control not present in the memory,
- by transmitting an unstored channel of a remote control already present in the me-
mory.
The procedures to activate the functions are described in the table.
NOTE: it is necessary to set to allow the
system configuration to be saved on the memory mo-
dule
To Next Page
Loading...
