Entrust nShield Connect - Page 42

Edit route entry
Enter the IP range
and mask length:
1. 1. 1. 1/ 1
Enter the gateway
2. 2. 2. 2
CANCEL FINISH
3.
Edit the IPv4 route entry Press the right-hand navigation button to accept the
changes.
9.2.7.2. Edit IPv6 route entry
To edit a route entry for IPv6:
1.
From the front panel menu, select System > System configuration > Network config
> Set up routing > Edit route entry.
The following screen is displayed:
Edit route entry
► 1. 1. 1. 1/ 1
3. 3. 3. 3/ 3
1111:1111:1111:1111:
1111:1111:1111:1111
/128
BACK SELECT
2.
Select the IPv6 route to be edited. Press the right-hand navigation button. The
following screen is displayed:
Edit route entry
Enter the IP range
and prefix length:
1111:1111::1111:1111:
Ê1111:1111:1111:1111/128
CANCEL NEXT
3.
Edit the IPv6 route entry Press the right-hand navigation button.
Edit route entry
1111:1111:1111:1111:
Ê1111:1111:1111:1111/128
Enter the gateway
2222:2222:2222:2222
BACK NEXT
nShield® Connect Installation Guide 42 of 73