Power button Display screen Status
On On, displaying menus and
dialogs
The module is operational.
On On, displaying messages but
not displaying labels for the
navigation buttons
The module is running an
upgrade. A color-coded
footer indicates the specific
status: yellow for
initialization, red
(maintenance) for upgrade.
On, flashes occasionally On, displaying messages but
not displaying labels for the
navigation buttons
The module is performing
start-up.
Mostly off, flashes
occasionally
Off The module is in Standby
mode (that is, it has been
powered down from the
front panel using the Power
button). Press the Power
button to turn it on.
Flashes regularly On, with “Critical Error”
message
The module is unable to
start-up or has failed. The
error message describes the
problem. If you can remedy
the problem, do so, and
press the Power button to
restart the module.
Otherwise, contact Support.
Flashes irregularly Off A low-level critical error has
occurred.
10.1.8. Ethernet LEDs
There are four Ethernet LEDs, two for each of the two Ethernet ports on the module. The
Ethernet LEDs indicate the status of the connection with other Ethernet devices.
nShield® Connect Installation Guide 59 of 73
To Next Page
Loading...
Need help?
General