Enttec OCTO - Settings and Direct Mode Configuration; Direct Mode Activation


USER GUIDE - v1.0
ID: 5928937
14 |
OCTO – 71521
Visit the ENTTEC website for
the latest version
Settings
The Settings page allows a user to do the following:
 Change a device name for identification
 Enable/disable DHCP
 Specify static network settings
 Set the output LED Protocol
 Set the number of mapped pixels
 Configure how colors are mapped to pixels through the Pixel Order function.
 Reset to factory defaults
 Reboot the device
Direct
Direct mode can be activated by clicking on the ‘Use Direct mode’ button on the Direct page as shown
in the image below.
When activated, the word Direct will be displayed next to the ENTTEC logo as shown in the
screengrab above: